How to fit a panel filter?
#1
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Jun 2008
Posts: 535
Likes: 0
Received 0 Likes
on
0 Posts
How to fit a panel filter?
I bought a K&N Panel filter for MY06 WRX.
Want to fit it myself, but have no clue where to start.
Don't flame me (am new to DIY work) but where does it go?
Pics would be helpful
Thanks
Want to fit it myself, but have no clue where to start.
Don't flame me (am new to DIY work) but where does it go?
Pics would be helpful
Thanks
#2
Cooking on Calor
iTrader: (23)
just find the air filter box and remove the lid by undoing the clips, clean all the crap out (if there is any) from the bottom of the box, and remove the old one and pop the new one in. put the lid back on and re fasten the clips. job done.
the arrow is pointing to the airbox. hth
the arrow is pointing to the airbox. hth
Last edited by Jamo; 06 March 2009 at 10:33 AM.
#3
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Jun 2008
Posts: 535
Likes: 0
Received 0 Likes
on
0 Posts
just find the air filter box and remove the lid by undoing the clips, clean all the crap out (if there is any) from the bottom of the box, and remove the old one and pop the new one in. put the lid back on and re fasten the clips. job done.
the arrow is pointing to the airbox. hth
the arrow is pointing to the airbox. hth
also how do i remove the socket with the wires that is plugged into the airbox??
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
Mattybr5@MB Developments
Full Cars Breaking For Spares
20
22 October 2015 06:12 AM
Bazil_SW
Engine Management and ECU Remapping
24
21 September 2015 11:55 PM
aaron_ions
General Technical
1
17 September 2015 10:42 AM