lowering on Standard struts without geo setup?
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Sep 2008
Posts: 550
Likes: 0
Received 0 Likes
on
0 Posts
lowering on Standard struts without geo setup?
am going to lower my car this wekeend on standard struts without a Geometry setup.
has anoyne done this? what are the implications? i could then get a geometry set up later in the month, but wont be straight away after i lowered it
edit will be 35mm on a standard stuts car 1995 wrx import.
ta
has anoyne done this? what are the implications? i could then get a geometry set up later in the month, but wont be straight away after i lowered it
edit will be 35mm on a standard stuts car 1995 wrx import.
ta
#3
Former Sponsor
Join Date: Dec 2005
Location: 10.68 QT mile in 2007 2.33 Type R ** Current 2002 Spec C 2.33 Track prepped.
Posts: 1,658
Likes: 0
Received 0 Likes
on
0 Posts
You can mark the existing camber bolts so they are near enough correct when you refit the legs. This would be a temp option until you have the alignment set up correct.
#5
Scooby Regular
iTrader: (46)
Join Date: Nov 2005
Location: Probably polishing it.Lol
Posts: 5,381
Likes: 0
Received 0 Likes
on
0 Posts
The camber bolts [x2] are located at the bottom of the strut that hold it onto the hub. One of them is a straight bolt and the other one is off centre so be sure to mark it like I didn't.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM