ok, have some gauges, boost is at standard 0.89 ish on my95 wrx import.

just bought a boost controller, how/ where abouts do i fit it to?

is the a tube from the boost solenoid to the turbo you need to splice and fit in there?

its not a dawes, its http://www.tweakit.net/shop/product_...tm_medium=feed

which is similar. and think fitting is the same.

want to up boost to 1.0 or 1.1, so how do you go about fitting these then?

 

It goes between the turbo nipple (high pressure side) and waste gate. You will need to block the pipe going to the boost control soleniod.

You will get part throttle full boost with this thing, which is very bad for the engine and a royal PITA to 'drive around'. Check out the Dawes website for more info.

It goes without saying that you will kill the engine if your fuelling is not up to it...