90 degree Boost Hose and Clamp
#1
90 degree Boost Hose and Clamp
Hi
Does anyone know if there is an uprated hose available for an STI that goes from the Turbo to the intercooler, the red one with the 90 degree bend?
Also are there any clamps on the market that are better than the standard hose clamps, ive heard that T hose clamps are good? What size would I need?
Keep blowing this pipe off every few weeks since the car was Re-mapped, im guessing that either the hose needs replacing or I should get another mapper to take a look make sure the idiot who mapped it didnt run too much boost.
Thanks in advance.
Does anyone know if there is an uprated hose available for an STI that goes from the Turbo to the intercooler, the red one with the 90 degree bend?
Also are there any clamps on the market that are better than the standard hose clamps, ive heard that T hose clamps are good? What size would I need?
Keep blowing this pipe off every few weeks since the car was Re-mapped, im guessing that either the hose needs replacing or I should get another mapper to take a look make sure the idiot who mapped it didnt run too much boost.
Thanks in advance.
#4
Scooby Regular
iTrader: (5)
Is it a new-age STi? If so, it's not just a 90deg bend - it's got an offset as well, so a simple 90deg hose will not do! (I made that mistake!)
Samco do one as part of a hose kit but they will supply the hose alone via a Samco dealer. The part No is TV1096 and is £34.84 + VAT
Viper Performance do very good clamps which have slightly rolled edges that will not bite into the hose. (They don't do the hose in question,though)
Viper Performance - High Quality Silicone Hoses
JohnD
Samco do one as part of a hose kit but they will supply the hose alone via a Samco dealer. The part No is TV1096 and is £34.84 + VAT
Viper Performance do very good clamps which have slightly rolled edges that will not bite into the hose. (They don't do the hose in question,though)
Viper Performance - High Quality Silicone Hoses
JohnD
Last edited by JohnD; 04 January 2009 at 05:52 PM.
#5
Thanks John thats great, yes it is a new age its a 55 plate Hawkeye, hopefully getting this problem sorted today, turn out that the pipe is fine, its down to the clamp, and possibly too much boost from the Re-map.
#6
Scooby Regular
iTrader: (5)
Did the hose come off, leaving the clamp behind? There's a lip on the turbo outlet so it would be impossible for a properly tightened clamp to slide off!
JohnD
Trending Topics
#9
If the clamp is tight enough the boost from a re-map should not pop the hose off! The standard hose and clamp on my STi with an MD321H pushing 1.65bar held OK
Did the hose come off, leaving the clamp behind? There's a lip on the turbo outlet so it would be impossible for a properly tightened clamp to slide off!
JohnD
Did the hose come off, leaving the clamp behind? There's a lip on the turbo outlet so it would be impossible for a properly tightened clamp to slide off!
JohnD
Got it put back on again lastnight, and the guy took the hose off cleaned it, and replaced it, its def on properly this time I watched him do it and the clamp is in the correct place and tight, so lets see what happens.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM