Notices
General Technical
Sponsored by:
Sponsored by: CARiD

ideling question

Thread Tools
 
Search this Thread
 
Old Dec 28, 2008 | 09:43 AM
  #1  
toigye's Avatar
toigye
Thread Starter
Scooby Regular
 
Joined: Feb 2004
Posts: 641
Likes: 0
From: belper
Default ideling question

my car as started to suffer from idel problem only from cold start up once warm runs fine , starts up first turn every time goes up to about 2000rpm and then starts to lower and raise again which seems to be almost flooding car to a stall any thoughts guys is it idel control valve .or coolant sensor maybe where do i start to look car is 1995 import saloon standard apart from dump valve and green panel filter but was running fine before with this setup..
Reply
Old Dec 28, 2008 | 10:33 AM
  #2  
Jolly Green Monster's Avatar
Jolly Green Monster
Former Sponsor
iTrader: (4)
 
Joined: Jan 2001
Posts: 16,548
Likes: 2
From: ECU Mapping - www.JollyGreenMonster.co.uk
Default

dump valve could be leaking.. if you have the orignal might be worth a swap to check..

otherwise sounds like coolant temp.. the idle valve is unlikely to make the revs go up and down from the ones I have seen that go faulty.. it either sticks at an openning and therefore you get too high or two low idle etc..

Simon
Reply
Old Dec 28, 2008 | 11:02 AM
  #3  
STI_Baly's Avatar
STI_Baly
Scooby Regular
iTrader: (23)
 
Joined: Feb 2008
Posts: 2,588
Likes: 1
From: My Workshop, Kent
Default

Ensure your coolant is topped up and system is re-circulating once hot.....this will ensure there's no air lock within the system itself..... i had a air lock in mine and the issue was the same as yours.....

My 2p's worth.
Reply
Old Dec 28, 2008 | 11:13 AM
  #4  
toigye's Avatar
toigye
Thread Starter
Scooby Regular
 
Joined: Feb 2004
Posts: 641
Likes: 0
From: belper
Default

cheers guys advice took on board will check car seems to drive as normal once reach normal temp
Reply
Old Dec 28, 2008 | 11:55 AM
  #5  
Jolly Green Monster's Avatar
Jolly Green Monster
Former Sponsor
iTrader: (4)
 
Joined: Jan 2001
Posts: 16,548
Likes: 2
From: ECU Mapping - www.JollyGreenMonster.co.uk
Default

good call on the coolant level.. years ago when I used the play with mk1 mr2's they lose any water and the idle jumps from normal to 1500rpm like you are blipping the throttle.. highly amusing.. and no one believes the solution
Reply
Old Dec 28, 2008 | 12:26 PM
  #6  
toigye's Avatar
toigye
Thread Starter
Scooby Regular
 
Joined: Feb 2004
Posts: 641
Likes: 0
From: belper
Default

ok guys just been out done a error code check all seems fine no codes so reset ecu and i will start on your advice thanks again

by the way where will i find coolant temp sensor on mine its a 1995 wrx import l reg , is it under the air pipe near the turbo does air pip have to come off to see it ,,,

Last edited by toigye; Dec 28, 2008 at 02:42 PM.
Reply
Old Dec 28, 2008 | 02:43 PM
  #7  
toigye's Avatar
toigye
Thread Starter
Scooby Regular
 
Joined: Feb 2004
Posts: 641
Likes: 0
From: belper
Default

bump
Reply
Old Dec 28, 2008 | 03:13 PM
  #8  
Jolly Green Monster's Avatar
Jolly Green Monster
Former Sponsor
iTrader: (4)
 
Joined: Jan 2001
Posts: 16,548
Likes: 2
From: ECU Mapping - www.JollyGreenMonster.co.uk
Default

Water cross pipe
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
KAS35RSTI
Subaru
27
Nov 4, 2021 07:12 PM
slimwiltaz
General Technical
20
Oct 9, 2015 07:40 PM
IanG1983
Wheels, Tyres & Brakes
2
Oct 6, 2015 03:08 PM
Brzoza
Engine Management and ECU Remapping
1
Oct 2, 2015 05:26 PM
the shreksta
Other Marques
26
Oct 1, 2015 02:30 PM




All times are GMT +1. The time now is 06:23 AM.