Can I get away with decat?
#1
Scooby Regular
Thread Starter
iTrader: (5)
Join Date: Sep 2007
Location: Hudds
Posts: 1,788
Likes: 0
Received 0 Likes
on
0 Posts
Can I get away with decat?
Thinking of putting a decat down pipe on my MY97 WRX. The only mods are K@N panel filter, samco Y-pipe, centre de-cat and Prodrive back. So is it advisable without a re-map? Obviously a re-map on this MY requires a new ECU and havent heard anything else about ECUTEK becoming available for a while. The Engines been rebuilt by scooby clinic 15k ago,
cheers jonny.
cheers jonny.
#2
check your ecu may be 4 pin at that age. thats the change ffrom 3 to 4.
my 97wrx is only 3 pin but some are 4 and your right you can't map them but i believe you can chip them and then map them.
my 97wrx is only 3 pin but some are 4 and your right you can't map them but i believe you can chip them and then map them.
Trending Topics
#9
Scooby Regular
Thread Starter
iTrader: (5)
Join Date: Sep 2007
Location: Hudds
Posts: 1,788
Likes: 0
Received 0 Likes
on
0 Posts
Hi mate, to be honest it doesnt feel much different from standard. The centre decat didn't make much difference apart from noise but the when I fitted the samco Y-pipe It did seem to pick up better and you can see why when you look at the pipe it replaces. I'm aiming to keep it simple i.e exhaust and induction. Also done few small mods like removing the throttle body coolant feed and intercooler tilt and splitter but the difference is negligable.
#10
Scooby Regular
Thread Starter
iTrader: (5)
Join Date: Sep 2007
Location: Hudds
Posts: 1,788
Likes: 0
Received 0 Likes
on
0 Posts
So the general thoughts are its safe to do. Will I see any noise difference? I want it louder but want to keep the prodrive BB, I like its understated look. Cheers for the replys
#11
Scooby Regular
Join Date: Feb 2003
Location: Zed Ess Won Hay Tee
Posts: 21,611
Likes: 0
Received 0 Likes
on
0 Posts
my 97wrx was fine.......
it was also fine with a swap to a td05 and a boost controller running at 1.45bar.....
it was also fine with a swap to a td05 and a boost controller running at 1.45bar.....
Last edited by StickyMicky; 29 November 2008 at 09:39 AM.
Thread
Thread Starter
Forum
Replies
Last Post
fatboy_coach
General Technical
15
18 June 2016 03:48 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM