power fc + pop, bang, flame
#1
power fc + pop, bang, flame
Hi,
Im sure this has been posted quite abit but i cant seem to get it to pop, bang, flame, i was advised by my mapper to go in2 settings, then rev/idle and to change the fuel cut off and change to rpm to 5000 so it keeps dumpin in fuel over run, but was told that once the car gets hot it will start to pop, bang, flame, but still cant, any ideas on how to?
Thanks
Im sure this has been posted quite abit but i cant seem to get it to pop, bang, flame, i was advised by my mapper to go in2 settings, then rev/idle and to change the fuel cut off and change to rpm to 5000 so it keeps dumpin in fuel over run, but was told that once the car gets hot it will start to pop, bang, flame, but still cant, any ideas on how to?
Thanks
#5
Scooby Regular
iTrader: (10)
Join Date: Dec 2006
Location: The valleys butt :)
Posts: 1,329
Likes: 0
Received 0 Likes
on
0 Posts
I haven't changed my fuel cut off rpm, it's set on 1050. The timing is on "0" though in the top row between 2000 and 4000 rpm if i remember right.
Get some pretty good pops an bangs too! Even better when it's hot!
I did turn the cut off up to try it and it did pop a bit more.
Get some pretty good pops an bangs too! Even better when it's hot!
I did turn the cut off up to try it and it did pop a bit more.
Thread
Thread Starter
Forum
Replies
Last Post