where do you put wires through the bulkhead?
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Sep 2008
Posts: 550
Likes: 0
Received 0 Likes
on
0 Posts
where do you put wires through the bulkhead?
installing a few gauges, and need to know where the best, most used place is to put wires through the bulkhead. i have oil pressure, temp and will have boost gauge wires all to go through
also which tube does the boost gauge t-join into?
also which tube does the boost gauge t-join into?
#2
Twatful
Join Date: Apr 2003
Location: Grew up and don't drive Scoobs anymore!
Posts: 9,050
Likes: 0
Received 0 Likes
on
0 Posts
In the engine bay on the drivers side you'll see a black rubber grommet, that thats the place, simply pop out the grommet, cut a cross in it and feed the wries through.
It comes into the footwell above the drivers pedals.
For a newage car t into the vacuum pipe off the dump valve on a classic there's a pipe on the manifold to tap into but can't recall which one, may be covered by a rubber cover.
It comes into the footwell above the drivers pedals.
For a newage car t into the vacuum pipe off the dump valve on a classic there's a pipe on the manifold to tap into but can't recall which one, may be covered by a rubber cover.
#4
Twatful
Join Date: Apr 2003
Location: Grew up and don't drive Scoobs anymore!
Posts: 9,050
Likes: 0
Received 0 Likes
on
0 Posts
#5
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Sep 2008
Posts: 550
Likes: 0
Received 0 Likes
on
0 Posts
cheers, the olny thing, i dfont have a spare nipple the three are all plumbed up. the one on the left, goes to the top of the dump valve, the other two are also connected
edit: and just to be clear it is a vacuum boost gauge with a pipe and nipple on the back of the gauge itself. where should this be attatched to
edit again: yes i am being retarded! hurrah!
can some plz just confirm that the pipe i want to t into is the small one comin g off the top of the dump valve?
ta
edit: and just to be clear it is a vacuum boost gauge with a pipe and nipple on the back of the gauge itself. where should this be attatched to
edit again: yes i am being retarded! hurrah!
can some plz just confirm that the pipe i want to t into is the small one comin g off the top of the dump valve?
ta
Last edited by Style; 20 September 2008 at 06:01 PM.
Thread
Thread Starter
Forum
Replies
Last Post