adzer

iTrader: (13)

can anyone tell me where i need to conect these wires, they are for my sigma m30 alarm, i know its thatcham approved so plz dont comment and say i shouldn't be doing it myself. i just need an alarm in the car before its stolen.

wires are:

1 - Blue - Interior light pin switches (neg)
2 - Blue/Red - Boot switch (neg)
3 - Green/Black - Low current programable output
4 - Green/Red - As above
5 - Black - Earth
6 - Black - Earth
7 - Orange - Ignition sense
8 - Red - 3a 12v
9 - Pink - Central locking (Configurable)
10 - Blue/White - As Above
11 - Black - Immobiliser circuit 1
12 - Black - Immobiliser circuit 1
13 - Black - Immobiliser circuit 2
14 - Black - Immobiliser circuit 2
15 - Red/Yellow - Indicator supply (15a)
16 - Yellow - Indicator output
17 - Yellow - Indicator output
18 - Green/Orange - Accessory output (neg during trigger)
19 - Green/White - Central locking (Configurable)
20 - Pink/Black - Central locking (Configurable)

i already made a post about this but some reason the link no longer works

NUTTYNICK

If you simply want to stuff it in so it protects the car then the alarm wires used are:

1 - Blue - Interior light pin switches (neg)
2 - Blue/Red - Boot switch (neg)
5 - Black - Earth (cable connected to same point as 6 if necessary)
6 - Black - Earth
7 - Orange - Ignition sense
8 - Red - 3a 12v
11 - Black - Immobiliser circuit 1 (either 11 and 12 or 13 and 14 or use both on different circuits. You basically cut a circuit ie fuel pump, ignition etc and connect one black wire to one end of the cut circuit and the other black wire to the cars other side of the cut circuit. Where you do this is the main reason for the cars security so don't be obvious)
12 - Black - Immobiliser circuit 1
13 - Black - Immobiliser circuit 2
14 - Black - Immobiliser circuit 2

The other cables are for making indicator flashers illuminate when you press the button etc. You'll need a wiring diagram for your car and take a good weekend to take internal panels, trim off to find the cables needed. Strip a certain amount of insulator off without cutting through the conductor and twist+solder the connections.

It's not too difficult to complete but you do need a good wiring diagram and preferably a mulit meter to ring out the wires and check for good earths etc.

By the way, the info above is common knowledge on the internet before anyone starts slating me

adzer

iTrader: (13)

what is confusing me is why is there four listed for central locking?
and all the alarms if wired up in the past normally only have 2 wires for the indicators but this has three???

i have good knowledge on how to wire alarms up but the way the list is worded is confusing me slightly

adzer

iTrader: (13)

bttt

MR_TOAD_INSTALLER

iTrader: (1)

indicators only have 2 wires
the other is the input wire to the on board relays this needs to be 12v

adzer

iTrader: (13)

does that mean i need to wire it to a 12v source from the indicator relay???

wire 8.....does that mean a 12v wire and fit a 3amp in line fuse???

why are there 4 central locking wires???

i'm just confused with it in general lol

adzer

iTrader: (13)

can someone tell me where wires 7, 8 & 15 should be wired upto?

plz