scoobyTaff

iTrader: (6)

ive recently bought some mods for my 94 wrx and was wondering with everythin plus a remap what sort of power will i be expecting to get,if anyone with a simular set up can give a rough idea of figures plz?

TD05 16g
255 walbro fp
fpr
bigger tmic
denso 550inj
"3"Turbo back system
Dawes device
Power FC & commander
apexi ind kit

myblackwrx

iTrader: (1)

94 wrx should have already had the td05 16g on it but for power wise could be upto 300bhp depending on how the mapper maps it but i would say about 280.
Not sure about the Dawes device/Power FC combo though.

banny sti

iTrader: (68)

With the mods they should net you around 340bhp but that will break your gearbox, also you will need to change your map sensor for a post 97 type,

As the early map sensor will not let you run more than 1.1 bar of boost, bear in mind if your engine has not been rebuilt it is 14 years old and will be a factor in the power the mods make.

Banny

scoobyTaff

iTrader: (6)

ahh ok,should of said in my first post i already had everything already on the car bar the "3" system,power fc,550inj,fpr and the engine has had a full forge rebuild. b4 all this it was mapped at 306bhp & 303lb just wonderd how much more power the above extra mods ive just got will give me and i have got a RA box rather than the wrx standard one?

thanks taff

banny sti

iTrader: (68)

You should get to around 340bhp and similar level of torque, with the additional mods.

Banny

New_scooby_04

iTrader: (4)

^^^^What he said^^^

RA95

looks very much the same as the first set of mods that went on my MY95, except I kept original intercooler.

I'd recommend an electronic boost controller with that lot (AVC-r).

My car dyno'd at 333bhp at 1.3 bar with that setup.

scoobyTaff

iTrader: (6)

thanks guys for all your help!

RB5 Boyo

What both them boys said

scoobyTaff

iTrader: (6)

if i wanted to push up to 400bhp or near as dam it,what more do i need?

scoobyTaff

iTrader: (6)

anyone?

doug2507

iTrader: (6)

Heads, pistons, rods, bearings, oil pump, turbo, headers, mapping, clutch/f.w, gearbox, suspension, brakes to mention just a few.......