engine out
06 July 2008, 05:35 PM
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: May 2008
Posts: 466
Likes: 0
Received 0 Likes
on
0 Posts
engine out
which is the last bolt to release on the gearbox to seperate from engine ive done the 4 main bolts. does the big allen key bolt under starter have to come out. any pictures would be handy
06 July 2008, 05:39 PM
#2
Scooby Regular
iTrader: (7)
Join Date: May 2008
Location: Kent
Posts: 1,169
Likes: 0
Received 0 Likes
on
0 Posts
yea...undo the hex bolt, and inside is a cylinder to release the cluch fork. To remove the cylinder you will need a 6mm bolt. Screw the 6mm bolt into the cylinder, and slowly pull it out. Pull the top of the clutch fork up, this will release the box from the engine..... it might take a wiggle to break the two away. See if you can jack the gearbox up a bit to get the right angle to ease it out...hope this helps...
been messin around all day with it
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM