Drivers Seat removal
#2
Unless you are doing something major you dont need to take the seat out.
If you only want access to the cable run try this...
Lever out the "inner inserts" of the square plugs on the cill covers.
Lever out the "outer" of the square plugs, then remove the plastic cill covers.
Carefully peel back the door rubber on the vertical door shut post and remove the grey inner cover (over the seat belt).
Peel back the carpet, then you will have access to white plastic "cover" and to the inner cill, cable route.
Good luck, Moles Dad.
If you only want access to the cable run try this...
Lever out the "inner inserts" of the square plugs on the cill covers.
Lever out the "outer" of the square plugs, then remove the plastic cill covers.
Carefully peel back the door rubber on the vertical door shut post and remove the grey inner cover (over the seat belt).
Peel back the carpet, then you will have access to white plastic "cover" and to the inner cill, cable route.
Good luck, Moles Dad.
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM