skcsteve

hi guys trying to get engine out of my subaru wrx sti got all bolts off engine is free but cant split ion from box ive undone 4 bolts from gearbox 2 from top one from bottom but it wont shift is there anything else i need to do

silent running

Have you pulled the clutch fork out from the release bearing?

skcsteve

how you mean

skcsteve

dont know what you mean if it matters this is a fluid clutch not a cable

andyxros

no you havent then if youve asked that lol.....on the bell housing top (say directly under inthercooler) there is a black piece of metel sticking out of a square rubber boot with the cluth slave cylinder attached and a spring. holding this black fork is a pin that slides in from passanger side, to gain acess to pin there is a cap with allen key hole un wind that then un wind the pin and pull it out and the fork will be free

skcsteve

ok ive taken out the allen key cap once out there is a another rod with a hole in it from there im not sure we tried screwing a 10mm bolt in there but it did nothing

jim litten

Screw a M6 bolt in and then you can pull the fork pivot pin out, then you'll need to pull the fork up out of the release bearing.

skcsteve

man yer a star engine is out thanks so much