What's needed for a fitting kit for a r2d2 sard BOV on a 93 wrx?
21 April 2008, 09:15 PM
#1
What's needed for a fitting kit for a r2d2 sard BOV on a 93 wrx?
Do I need a t-piece of a certain size?
Could someone post some pics of there BOV fittings as i've only seen them on the intercooler, but the pics weren't very clear and couldn't quite work out how it had been set up.
Many thanks
Oh anyone know the best place to get the parts from?
Could someone post some pics of there BOV fittings as i've only seen them on the intercooler, but the pics weren't very clear and couldn't quite work out how it had been set up.
Many thanks
Oh anyone know the best place to get the parts from?
22 April 2008, 03:50 PM
#3
Scooby Regular
iTrader: (1)
Join Date: Aug 2005
Location: Manchester ish
Posts: 18,547
Likes: 0
Received 0 Likes
on
0 Posts
hi, if it is a vent to atmosphere then you dont need a t piece on a my93, what you will need is a suitable diameter silicon hose that is on your existing take off point, that mateches your new BOV.
The other side (towards the turbo elbow) you will require a suitable bung/cap to block of the hole that will appear once you remove the recirc.
You will probably be okay with the vacuum tube that goes on the top of the bov
The likes of Demon Tweeks are good for the silicone hoses, and there is also merlin motorsport
The other side (towards the turbo elbow) you will require a suitable bung/cap to block of the hole that will appear once you remove the recirc.
You will probably be okay with the vacuum tube that goes on the top of the bov
The likes of Demon Tweeks are good for the silicone hoses, and there is also merlin motorsport
Thread
Thread Starter
Forum
Replies
Last Post
aaron_ions
General Technical
17
03 November 2021 11:07 AM
Scooby-Doo 2
Wheels And Tyres For Sale
1
09 September 2015 06:51 PM