dta
#2
Also known as daz
Dta will run, you will need one that can control turbo'ed cars, not all of them will so bear that in mind.
The best method would be to replace your entire loom, you would be looking at least £200 for a decent loom if not more, but most of the cabling will be marked for the appropriate sensor.
It is a good ecu but bear in mind a lot of subaru specialists won't be that versed with it.
Two i can think of would be alan jeffrey in plymouth and emerald somewhere around leicester way.
Personally id fit an apexi or even better a simtek and have done with it, much less hassle and you can map both yourself should you wish though you would need to be experienced in 3d mapping of course.
Hth
The best method would be to replace your entire loom, you would be looking at least £200 for a decent loom if not more, but most of the cabling will be marked for the appropriate sensor.
It is a good ecu but bear in mind a lot of subaru specialists won't be that versed with it.
Two i can think of would be alan jeffrey in plymouth and emerald somewhere around leicester way.
Personally id fit an apexi or even better a simtek and have done with it, much less hassle and you can map both yourself should you wish though you would need to be experienced in 3d mapping of course.
Hth
Thread
Thread Starter
Forum
Replies
Last Post