gems problem- one for the mappers
Thread Starter
Scooby Regular
Joined: Mar 2005
Posts: 729
Likes: 0
From: "Speed has never killed anyone, suddenly becoming stationary...Now that's what gets you."
gems problem- one for the mappers
does my TPS signal scale and my TPS load have to match?
reason i ask is because i can scale the the TPS to work fine but when this works fine my TPS TO LOAD will only will go up to 25% of my scale.
if i swap the wires around on the TPS plug then i can scale the TPS TO LOAD fine but then at 25% throttle i seeing 100%WOT.
vehicle harness has 4pin plug but i'm using a later 3pin TPS sensor. i have tryied all wiring configurations but still i cant solve my problem.
tomorrow i will get some time to play with it instead of ten mins here and there
mark
reason i ask is because i can scale the the TPS to work fine but when this works fine my TPS TO LOAD will only will go up to 25% of my scale.
if i swap the wires around on the TPS plug then i can scale the TPS TO LOAD fine but then at 25% throttle i seeing 100%WOT.
vehicle harness has 4pin plug but i'm using a later 3pin TPS sensor. i have tryied all wiring configurations but still i cant solve my problem.
tomorrow i will get some time to play with it instead of ten mins here and there
mark
Last edited by mark28; Apr 10, 2008 at 10:08 PM.
Thread
Thread Starter
Forum
Replies
Last Post