Another Exhaust Question
#1
Scooby Regular
Thread Starter
iTrader: (8)
Join Date: Aug 2007
Posts: 411
Likes: 0
Received 0 Likes
on
0 Posts
Another Exhaust Question
Right then
99 STI JDM V5
Strut brace off
intercooler off
heat shield off
skin from knuckles off
everything wd40'd in prep for tomorrow morning when i will attempt to remove the down-pipe to fit the de-cat scoobyworld H&S downpipe.
QUESTION...........are you ready?
Is the sensor currently in the cat on my car a heat sensor only (thus not necessary after removal)
or is it required for fuel/air/ratio mixtures and ultimately will cause me problems without?
Thanks peoples
-A
99 STI JDM V5
Strut brace off
intercooler off
heat shield off
skin from knuckles off
everything wd40'd in prep for tomorrow morning when i will attempt to remove the down-pipe to fit the de-cat scoobyworld H&S downpipe.
QUESTION...........are you ready?
Is the sensor currently in the cat on my car a heat sensor only (thus not necessary after removal)
or is it required for fuel/air/ratio mixtures and ultimately will cause me problems without?
Thanks peoples
-A
#3
Scooby Regular
Thread Starter
iTrader: (8)
Join Date: Aug 2007
Posts: 411
Likes: 0
Received 0 Likes
on
0 Posts
i haven't seen more than one hole for a sensor, the only i can see is directly begind the turbo and the H&S downpipe has a hole cut for this. Which one would this be?
Lamda required right?
Lamda required right?
Thread
Thread Starter
Forum
Replies
Last Post
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM