Notices
General Technical
Sponsored by:
Sponsored by: CARiD

engine check light

Thread Tools
 
Search this Thread
 
Old Mar 7, 2008 | 08:07 AM
  #1  
clivejones's Avatar
clivejones
Thread Starter
Scooby Regular
 
Joined: Mar 2008
Posts: 110
Likes: 0
Default engine check light

hi looking for help
engine check light comes on when car up to temp it goes off anyone with advice for me
thanks clive
Reply
Old Mar 7, 2008 | 08:46 AM
  #2  
myblackwrx's Avatar
myblackwrx
Scooby Regular
iTrader: (1)
 
Joined: Mar 2006
Posts: 8,787
Likes: 1
From: Dorset
Default

You can check for error codes here www.JollyGreenMonster.com - Engine management specialist on the help page (only if it's a classic shaped impreza though)
Reply
Old Mar 7, 2008 | 11:49 AM
  #3  
clivejones's Avatar
clivejones
Thread Starter
Scooby Regular
 
Joined: Mar 2008
Posts: 110
Likes: 0
Default engine light

right done a check it come up as 22 knock sensor any ideas how to cure fault
Reply
Old Mar 7, 2008 | 01:50 PM
  #4  
clivejones's Avatar
clivejones
Thread Starter
Scooby Regular
 
Joined: Mar 2008
Posts: 110
Likes: 0
Default light

anyone got detailed advice on fiitting a knock sensor
Reply
Old Mar 8, 2008 | 05:17 PM
  #5  
Redbelly's Avatar
Redbelly
Scooby Newbie
 
Joined: Jan 2008
Posts: 27
Likes: 0
From: Reading
Default

Remove intercooler and and blow off valve,look on the left hand of the block(the cars left not yours) you will see and round sensor bolted down with one 12mm through the sensor,use a snap on shallow magnetic socket on a 12'' extension to remove the bolt undo the small white multi plug to the sensor and pull out the sensor,clean the engine block where the sensor bolts down(important as the sensor earths to the block) set your new sensor over the bolt hole,lube the bolt and gently wind it in to 15nm any more will damage the sensor,connect multi plug and re install all the componets,clear the memory and done...easy
Reply
Old Mar 8, 2008 | 06:04 PM
  #6  
rbaz's Avatar
rbaz
Scooby Regular
iTrader: (1)
 
Joined: Jan 2008
Posts: 1,695
Likes: 0
From: France
Default

Mine had the same error code when I got the sensor off it had a split in the casing.
I ordered one from the US saved a fortune. About $65 just over £30 with the postage. Dealer in UK wanted about £120.

Should be here Monday so hopefully all running again then
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
bugeye269
General Technical
2
Sep 27, 2015 11:05 PM
TylerD529
Lighting and Other Electrical
5
Sep 20, 2015 12:10 PM
Bingerz1981
General Technical
1
Sep 15, 2015 10:03 PM
slimwiltaz
General Technical
7
Sep 12, 2015 07:54 AM




All times are GMT +1. The time now is 05:58 AM.