Bent droplinks / rear anti-roll bar/mechanism
#1
Bent droplinks / rear anti-roll bar/mechanism
Just wondering if anyone could advise. I took my car to a private garage about 6 months ago (car is a 2004 STI) as damaged (bent) droplinks on the anti-roll bar were evident. These were replaced and all appeard to be working fine until the cars service today when the same problem has re-occured. Nothing out of the ordinary has happened to the car and I have been advised that the speed bumps (of which I drive over cautiously each day) near where I live would not have cause damage to this extent.
Does anyone know what could cause such a re-occureence so quickly? I'm now concerned there is something more sinister (expensive) causing this issue?
Thanks.
Last edited by JB2004; 06 March 2008 at 07:35 PM. Reason: Image
#2
Scooby Regular
it looks to be in the wrong position for starters, thuis could cause the damage??
the roll bar should be above the lower arm and the d/link pointing up and down..........
alyn
the roll bar should be above the lower arm and the d/link pointing up and down..........
alyn
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
shorty87
Full Cars Breaking For Spares
19
22 December 2015 11:59 AM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM