I have just read the fault codes on my ecu,the only one it comes up with is code 11 which is crank angle sensor,is this anything to be worried about,hpoefully in the next few weeks an Apexi Power FC will be fitted and mapped,also a new cambelt is due to be fitted

 

reset ecu and see if it reoccurs

do you disconnect it when changing oil?

 

I will do a reset shortly,only disconnect crank sensor after oil change complete,just to turn engine over to get oil circulated before firing up engine.

Also JGM,i would like you to do the remap on my car,hopefully in a couple of weeks i know you charge £250 for this,and i know you would travel,but what expenses would you charge for traveling to Wrexham North Wales ?

 

so hopefully the code is old from your last oil change

yeah sure..

looking at about £60 to travel up..

I am actually up early next month already.. would make fuel costs cheaper

email to discuss if you like www.JollyGreenMonster.com - Engine management specialist

Simon