Notices
General Technical
Sponsored by:
Sponsored by: CARiD

ecu pin numbers

Thread Tools
 
Search this Thread
 
Old Dec 30, 2007 | 06:52 PM
  #1  
thewhitewarrior's Avatar
thewhitewarrior
Thread Starter
Scooby Regular
 
Joined: Jan 2007
Posts: 909
Likes: 0
From: in the engine bay
Default ecu pin numbers

i am trying to find the pin numbers on the ecu for the coil packs, i have only got a spark on the no4 plug, so i just want to check if there is a signal from the ecu to tell the engine to spark on the other plugs, does anyone know which pins they are, cheers phil.
Reply
Old Dec 30, 2007 | 07:38 PM
  #2  
N602 WRX's Avatar
N602 WRX
Scooby Regular
 
Joined: May 2006
Posts: 155
Likes: 0
From: washington
Default

b44 plug (biggest one)
cylinder 1-pin 10
cylinder 2-pin 9
cylinder 3-pin 8
cylinder 4-pin 7
Reply
Old Dec 30, 2007 | 08:13 PM
  #3  
thewhitewarrior's Avatar
thewhitewarrior
Thread Starter
Scooby Regular
 
Joined: Jan 2007
Posts: 909
Likes: 0
From: in the engine bay
Default

thanks, ill take a look tomorrow, is there numbers on the ecu or on the plug, or is it just knowing where number 1 is and go from there, have you got any diagrams on all the pins, or is there somewhere i can look on the net, cheers phil.
Reply
Old Dec 30, 2007 | 10:04 PM
  #4  
N602 WRX's Avatar
N602 WRX
Scooby Regular
 
Joined: May 2006
Posts: 155
Likes: 0
From: washington
Default

Tryed to upload the picture to no avail! If you do a search on here im sure youl find it! But if your looking at the ecu in the car, its the plug at the top. it will have 2 rows of 13. there numbered right to left, so '1' is in the top right corner of the plug
Reply
Old Dec 30, 2007 | 10:34 PM
  #5  
Jolly Green Monster's Avatar
Jolly Green Monster
Former Sponsor
iTrader: (4)
 
Joined: Jan 2001
Posts: 16,548
Likes: 2
From: ECU Mapping - www.JollyGreenMonster.co.uk
Default

try here

Simon
Reply
Old Dec 31, 2007 | 08:47 AM
  #6  
thewhitewarrior's Avatar
thewhitewarrior
Thread Starter
Scooby Regular
 
Joined: Jan 2007
Posts: 909
Likes: 0
From: in the engine bay
Default

thanks for the help once again simon, you site is pretty helpfull, cheers phil.
Reply
Old Dec 31, 2007 | 10:27 AM
  #7  
thewhitewarrior's Avatar
thewhitewarrior
Thread Starter
Scooby Regular
 
Joined: Jan 2007
Posts: 909
Likes: 0
From: in the engine bay
Default

is there any way to wire up the coils from the ecu, or do the wires from the ecu go to somewhere before going to the coils, i think my loom has some brakes in it, cheers phil.
Reply
Old Dec 31, 2007 | 10:40 AM
  #8  
Jolly Green Monster's Avatar
Jolly Green Monster
Former Sponsor
iTrader: (4)
 
Joined: Jan 2001
Posts: 16,548
Likes: 2
From: ECU Mapping - www.JollyGreenMonster.co.uk
Default

they go to the ignitor on the drivers inner wing.. however iirc you have just fitted the engine? I doubt it is related to wiring, although double check the plugs by the battery, unconnect and reconnect incase they are dirty etc..

problem sounds more like cam wheels or crank / cam sensor problem.

Simon
Reply
Old Dec 31, 2007 | 10:46 AM
  #9  
thewhitewarrior's Avatar
thewhitewarrior
Thread Starter
Scooby Regular
 
Joined: Jan 2007
Posts: 909
Likes: 0
From: in the engine bay
Default

i forgot to mension, the car has had some other work done and could have disturbed a few wires, where abouts in the drivers inner wing is the ignitor, and what does it look like, cheers phil.
Reply
Old Dec 31, 2007 | 12:07 PM
  #10  
Jolly Green Monster's Avatar
Jolly Green Monster
Former Sponsor
iTrader: (4)
 
Joined: Jan 2001
Posts: 16,548
Likes: 2
From: ECU Mapping - www.JollyGreenMonster.co.uk
Default

on the back of the bracket the boost solenoid is on etc, flat and square about 2inches across
Reply
Old Dec 31, 2007 | 01:52 PM
  #11  
thewhitewarrior's Avatar
thewhitewarrior
Thread Starter
Scooby Regular
 
Joined: Jan 2007
Posts: 909
Likes: 0
From: in the engine bay
Default

i changed it for another, and it was that, yeeeeehoooo, BUT it turned off after about fifteen minutes and now wont start, when the ignition is turned on the check engine light isnt on any more, any ideas, thanks phil.
Reply
Old Dec 31, 2007 | 02:12 PM
  #12  
thewhitewarrior's Avatar
thewhitewarrior
Thread Starter
Scooby Regular
 
Joined: Jan 2007
Posts: 909
Likes: 0
From: in the engine bay
Default

oh and it doesnt click any relays or the fuel pump doesnt come on, is there a main fuse or something that have gone.
Reply
Old Dec 31, 2007 | 02:32 PM
  #13  
Jolly Green Monster's Avatar
Jolly Green Monster
Former Sponsor
iTrader: (4)
 
Joined: Jan 2001
Posts: 16,548
Likes: 2
From: ECU Mapping - www.JollyGreenMonster.co.uk
Default

see other thread
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
Dec 28, 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
Nov 18, 2015 07:03 AM
Ganz1983
Subaru
5
Oct 2, 2015 09:22 AM
thunder8
General Technical
0
Oct 1, 2015 09:13 PM
Raptorman
ScoobyNet General
0
Oct 1, 2015 06:46 PM




All times are GMT +1. The time now is 12:02 PM.