Notices
General Technical
Sponsored by:
Sponsored by: CARiD

noise from cold start??

Thread Tools
 
Search this Thread
 
Old Dec 22, 2007 | 10:08 PM
  #1  
wardy32's Avatar
wardy32
Thread Starter
Scooby Regular
 
Joined: Dec 2007
Posts: 65
Likes: 0
From: just down the road from old bob whos currently in the potting shed!
Question noise from cold start??

hope someone can help a little with the following???

have got a '98 type r which has had a bottom end rebuild only 7k ago but noticed this morning that the engine was knocking/tapping a little until oil came up to temp after that nothing at all and drives superb.

any ideas what this could be???
Reply
Old Dec 22, 2007 | 10:57 PM
  #2  
Jolly Green Monster's Avatar
Jolly Green Monster
Former Sponsor
iTrader: (4)
 
Joined: Jan 2001
Posts: 16,548
Likes: 2
From: ECU Mapping - www.JollyGreenMonster.co.uk
Default

pistons slap most likely.. nothing to overly worry about..

Simon
Reply
Old Dec 22, 2007 | 11:01 PM
  #3  
wardy32's Avatar
wardy32
Thread Starter
Scooby Regular
 
Joined: Dec 2007
Posts: 65
Likes: 0
From: just down the road from old bob whos currently in the potting shed!
Default

piston slap??

so is that causing any damage to the engine???
Reply
Old Dec 22, 2007 | 11:22 PM
  #4  
Jolly Green Monster's Avatar
Jolly Green Monster
Former Sponsor
iTrader: (4)
 
Joined: Jan 2001
Posts: 16,548
Likes: 2
From: ECU Mapping - www.JollyGreenMonster.co.uk
Default

pistons is rattling in the bore due to clearances fairly large when engine is cold..

as long as it is a continuous tick / knock matching the rpm and goes when engine warm then it sounds like piston slap.. do a search on here on "piston slap" you should find sound clips.. if it is not matching rpm then it would be something to worry about.

Simon
Reply
Old Dec 22, 2007 | 11:41 PM
  #5  
rigga's Avatar
rigga
Scooby Regular
iTrader: (4)
 
Joined: May 2005
Posts: 1,966
Likes: 0
From: midlands......
Default

Wouldn't a fairly recent bottom end rebuild taken care of the piston slap issue though? New pistons matched to bore size a bit better than the originals that had a tendancy to do it when cold.
Reply
Old Dec 23, 2007 | 12:04 AM
  #6  
Jolly Green Monster's Avatar
Jolly Green Monster
Former Sponsor
iTrader: (4)
 
Joined: Jan 2001
Posts: 16,548
Likes: 2
From: ECU Mapping - www.JollyGreenMonster.co.uk
Default

depends whether the pistons were changed, if so which make etc.. the drop in pistons will do it.. most rebuilds won't necessarily replace pistons, depends if there is bore damage..

Simon
Reply
Old Dec 23, 2007 | 12:53 AM
  #7  
butler's Avatar
butler
Scooby Regular
 
Joined: Apr 2006
Posts: 95
Likes: 0
From: edinburgh
Default

Think i have piston slap on mine too. Tried a search for a sound clip but none work, does anyone have a sound file?
Reply
Old Dec 23, 2007 | 02:38 AM
  #8  
big-kev's Avatar
big-kev
Scooby Regular
 
Joined: Sep 2007
Posts: 497
Likes: 6
From: belfast
Default

mate i have a 97 sti and it does the same for about 2mins on a cold start then goes away , you will propibly find it is the cold weather which does,nt help ether but as far as i know most scoobys sound like this
do,nt worry to much
p.s have a good xmas
big-kev
Reply
Old Dec 23, 2007 | 09:06 AM
  #9  
scoobynewbie72's Avatar
scoobynewbie72
Scooby Regular
iTrader: (1)
 
Joined: Feb 2007
Posts: 1,605
Likes: 0
From: Here
Default

Sounds daft but is it defo from the engine?
I know a few who get a ticking from the gearbox when its cold, once its warmed up it can go away.
hth
Brett
Reply
Old Dec 23, 2007 | 09:07 AM
  #10  
BOB.T's Avatar
BOB.T
Scooby Senior
 
Joined: Jul 2001
Posts: 14,810
Likes: 0
From: Radiator Springs
Default

Hydraulic tappets can also make a tapping noise untill they fill with oil.
Reply
Old Dec 23, 2007 | 10:17 AM
  #11  
StickyMicky's Avatar
StickyMicky
Scooby Regular
 
Joined: Feb 2003
Posts: 21,611
Likes: 0
From: Zed Ess Won Hay Tee
Default

mine has slapped from cold for 5 years and has even been rebuilt

nothing to worry about
Reply
Old Dec 23, 2007 | 04:28 PM
  #12  
wardy32's Avatar
wardy32
Thread Starter
Scooby Regular
 
Joined: Dec 2007
Posts: 65
Likes: 0
From: just down the road from old bob whos currently in the potting shed!
Default

seems like i need to check a bit further into the noise then to make sure but cheers all for the advise..

fingers crossed it doesnt cost too much!!!...yeh i know silly answer its a scooby its gonna cost loads..anyway ho ho ho merry xmas all!!!!
Reply
Old Dec 24, 2007 | 12:53 PM
  #13  
Scoobyslammed's Avatar
Scoobyslammed
Scooby Regular
20 Year Member
Liked
Loved
 
Joined: Nov 2003
Posts: 1,920
Likes: 27
From: Cheshire
Wink

Tappets arn't hydraulic on a ver4...
Forged bottom ends will normally make alittle noise until warmed up... nothing to worry about...
Aslong as it quiter when warm wouldn't worry too much...
Reply
Old Dec 24, 2007 | 01:10 PM
  #14  
Pittys sti's Avatar
Pittys sti
Scooby Regular
 
Joined: May 2007
Posts: 88
Likes: 0
From: Kingswood Bristol
Default

Anyone tried putting Wynns supercharge in with their oil? Ive been told it might make my bugeye sti quieter.
Reply
Old Dec 24, 2007 | 05:20 PM
  #15  
scooby2boo's Avatar
scooby2boo
Scooby Newbie
 
Joined: Dec 2007
Posts: 1
Likes: 0
Default

ive just bought my first scooby and it my first turbo riceburner - im usually a bigblock man, i also have noticed 'ticking' sounds a bit like noisey injectors, dosnt really go away though????? what do you think? from what you all say its pretty normal? cheers for any help
Reply
Old Dec 24, 2007 | 10:25 PM
  #16  
rigga's Avatar
rigga
Scooby Regular
iTrader: (4)
 
Joined: May 2005
Posts: 1,966
Likes: 0
From: midlands......
Default

Ticking noise like noisy injectors?........ poss noisy injectors as they all do that,piston slap is another noise altogether.
Reply
Old Dec 24, 2007 | 10:58 PM
  #17  
Jolly Green Monster's Avatar
Jolly Green Monster
Former Sponsor
iTrader: (4)
 
Joined: Jan 2001
Posts: 16,548
Likes: 2
From: ECU Mapping - www.JollyGreenMonster.co.uk
Default

agree, or tappets if early car
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
KAS35RSTI
Subaru
27
Nov 4, 2021 07:12 PM
FuZzBoM
Wheels, Tyres & Brakes
16
Oct 4, 2015 09:49 PM
Ganz1983
Subaru
5
Oct 2, 2015 09:22 AM
Phil3822
ScoobyNet General
33
Oct 2, 2015 03:22 AM
legb4rsk
Non Scooby Related
14
Oct 1, 2015 05:18 AM




All times are GMT +1. The time now is 07:00 AM.