hello Im just about to buy a blitz sus power induction kit for my 95 jdm wrx and was wondering what are your thoughts on the kit,also going to fit a greddy profec 2 boost controller. would I be right in thinking that 1.1bar is a safe limit to go to,running a standard turbo or can we get a bit more??

 

is the sus ,the mesh cone type, if so I'm selling one if your interested.its of a v6 sti.

 

1.2 bar but may be worth uprating the fuel pump first and i would go for an Apexi IK

 

to be fair thats what i'd buy aswell, I'm not using the mesh blitz after i read an article where it was tested along with the K&N cone apexi and hks ,the blitz was worst for letting dirt through, the apexi came up best in all areas,

 

Nowt wrong with std imho

 

nice one mate,but after reading the other posts I'm now going for a apexi IK. cheers for the offer though.

 

I've had to replace the fuel pump due to the standard one giving up. had a walbro 255 fitted is this good enough .the 1.2 bar is all good, can I run at this for long periods or just as a short burst. I'm still new to increasing boost and dont want to go bang.Only just getting over the head gasket going about 6 months ago.... nice s/s gaskets on board now though.

 

Walbro is highly recommended so you're sorted there.

For another solution instead of the boost controller is Enduring Solutions Limited.

I would make the 1.2 bar peak boost not held imo.

 

dont laugh... but imo what does it mean???

 

imo = in my opinion
imho = in my humble opinion..

Simon

 

cheers all. looking foward to a fun day fitting the little beauties now. then off to the rolling road to see just how much she's putting out