Looking for help or a guide on fitting a HKS EVC. Ive got the manuals, but im a bit of a numpty when its comes to these things.

As they say pictures speak a thousand words.

Cheers Slippy

 

top

 

I'm gonna need this info too shortly. Did you download your manual off the net?

 

No bought the kit 2nd hand off Andy McG, with everything supplied, including jap & uk manual. Just I would prefer to see a guide before I make a mess of it.

 

1. bolt stepping motor to drivers-side turrent
2. port b - goes to compressor bypass signal line
3. port i - goes to turbocharger
4. port o - goes to wastegate


question what is number 2, where is it ?

Im I right in thinking, do I just use the same places as the 3 port solenoid goes

 

found this fitting guide to an evo

HKS EVC-4 Install

 

Got this diagram from the jap install manual










1. bolt stepping motor to drivers-side turrent
2. port b - goes to compressor bypass signal line - LOOK AT ABOVE PICTURE
3. port i - goes to turbocharger
4. port o - goes to wastegate
5. LEARN HOW TO SPELL SOLENOID... LMAO

 

Manual is all you need mate its a doddle!

 

P.S. I mounted the solenoid ontop of the original boost controller bracket, fits a treat

 

*Update Time*

The Hks Boost Controller all fitted and setup. Ive set the boost to 120 kpa or 1.2 bar along with the mines ecu. To be honest ive havent noticed any differrence over my previous set-up, which was a dawes fitted and set to 1.0 bar along with the mines ecu. What I have noticed is the noise level has gone up from the boost, quite noticeable, where as the dawes was fairly quiet.


My personal opinion, my ££ would of been better spend else where. I would be interested in others thoughts on this.