sti crankshaft info
#1
sti crankshaft info
hi
ive just brought sti crank for a 1994 sti and im not sure if there's any difference in the crank for the thrust bearing location,either the crank can be run on the rear thrust or the centre thrust.is there any difference?
if so what should i look out for on the crank?is there any markings?
thanks si
ive just brought sti crank for a 1994 sti and im not sure if there's any difference in the crank for the thrust bearing location,either the crank can be run on the rear thrust or the centre thrust.is there any difference?
if so what should i look out for on the crank?is there any markings?
thanks si
#4
Former Sponsor
iTrader: (20)
Join Date: Oct 2006
Location: 8.95 @ 168mph. Zero to 1KM 194.1mph
Posts: 1,150
Likes: 0
Received 0 Likes
on
0 Posts
The crank for a 92-98 engine block should be center thrust, and there would only be one position on a 92-98 block for the thrust baring to be fitted.
The crank pt.no should end with 150.
Mark.
The crank pt.no should end with 150.
Mark.
Trending Topics
#9
ok ive now checked the thrust bearing on centre of the crank,it fits like a glove on the sides but theres a little movement between the bearing and journal,this is normal i think because ive tryed my old 1's and there a bit worn.try it on the rear thrust and move side to side.
£100 i payed for this crank with connecting rods still attatched and its like a brand new crank
cheers
si
£100 i payed for this crank with connecting rods still attatched and its like a brand new crank
cheers
si
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Car Parts For Sale
1
18 November 2015 07:49 AM