A few Innovate LC-1 questions.
#1
A few Innovate LC-1 questions.
I am fitting my LC-1 tomorrow and have just about sorted the details of the fitment. I do have a couple of niggles though.
1) Is the analogue output that simulates the narrowband signal already programmed to the right settings?
2) Can I feed this analogue signal directly to the correct (yet to find out for MY98) pin on the ecu?
3) The second wideband output is going to feed a DB wideband display AND datalogit. Can thjis be done? or is it a case of switching the signal between the guage and datalogit?
Other than that, I think I'm sorted.
Unless there is other advice?
Cheers,
Wayne.
1) Is the analogue output that simulates the narrowband signal already programmed to the right settings?
2) Can I feed this analogue signal directly to the correct (yet to find out for MY98) pin on the ecu?
3) The second wideband output is going to feed a DB wideband display AND datalogit. Can thjis be done? or is it a case of switching the signal between the guage and datalogit?
Other than that, I think I'm sorted.
Unless there is other advice?
Cheers,
Wayne.
#2
Fitted!
Got it fitted today and it seems to emulate the narrowband signal nicely.
The commaner for the Power FC shows a nice fluctuation around the 0.45v mark. So, it looks like the preprogrammed output on analogue 1 is ok.
Now, I still need to know if the wideband output on analogue 2 is ok to feed a gauge AND the datalogit at the same time? Or, do I need to switch the gauge off when logging data to get the correct signal?
Cheers for any help,
Wayne.
The commaner for the Power FC shows a nice fluctuation around the 0.45v mark. So, it looks like the preprogrammed output on analogue 1 is ok.
Now, I still need to know if the wideband output on analogue 2 is ok to feed a gauge AND the datalogit at the same time? Or, do I need to switch the gauge off when logging data to get the correct signal?
Cheers for any help,
Wayne.
Thread
Thread Starter
Forum
Replies
Last Post
Mister:E
Subaru Parts
2
24 September 2015 01:37 PM
ossett2k2
Engine Management and ECU Remapping
15
23 September 2015 09:11 AM
BHPvstorque
Subaru Parts
1
14 September 2015 08:31 PM