whole in block
#1
whole in block
my sti has popped a con rod took engine out have nice big whole on front passanger side so now need a bottom end what mods is needed for 2.5 or are they just a straight swap also would my mahle pistons fit this block
cheers dan
cheers dan
#2
Scooby Senior
Block, gaskets and a remap will do, but I'd advise at least a set of drop in pistons to future proof it.
2.0 bore is 92.5mm 2.5 are 99.5mm and you'll prob find that one the pistons isn't as it should be if it put a rod through the block
you will see boost a lot earlier on a 2.5
2.0 bore is 92.5mm 2.5 are 99.5mm and you'll prob find that one the pistons isn't as it should be if it put a rod through the block
you will see boost a lot earlier on a 2.5
#3
Block, gaskets and a remap will do, but I'd advise at least a set of drop in pistons to future proof it.
2.0 bore is 92.5mm 2.5 are 99.5mm and you'll prob find that one the pistons isn't as it should be if it put a rod through the block
you will see boost a lot earlier on a 2.5
2.0 bore is 92.5mm 2.5 are 99.5mm and you'll prob find that one the pistons isn't as it should be if it put a rod through the block
you will see boost a lot earlier on a 2.5
cheers dan
#5
Scooby Regular
iTrader: (1)
Block, gaskets and a remap will do, but I'd advise at least a set of drop in pistons to future proof it.
2.0 bore is 92.5mm 2.5 are 99.5mm and you'll prob find that one the pistons isn't as it should be if it put a rod through the block
you will see boost a lot earlier on a 2.5
2.0 bore is 92.5mm 2.5 are 99.5mm and you'll prob find that one the pistons isn't as it should be if it put a rod through the block
you will see boost a lot earlier on a 2.5
Standard 2.0l bore size is 92.00mm, 92.50 is Oversize
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
bluebullet29
General Technical
9
05 October 2015 02:17 PM