Hi

i've got a HKS EVC IV boost controller fitted to my Evo5. I'm wanting to lower the high boost setting from 1.25bar to 1.2bar. Does anybody know how to do it as i haven't got a manual or clue how to do it :roll:

Don't just wanna start pressing buttons to find out how it works cos i'm likely to break something :wink:

Oh & i've found the pdf manual for it but i can't find anything that tells me how to alter it once it's all been set. Just tells me how to set it all from scratch with learning mode etc & i don't wanna reset it & start from scratch. Don't wanna bugger it up totally

BTW i do realize this is a Scooby forum & i have an Evo but i've asked on here cos generally a lot more people use this forum & technically it's not an Evo issue, it's a HKS product issue

Thanks in advance


Craig 8)

 

Come on!!!

Somebody on here must have a EVC IV & know how to use it??


Craig

 

Whilst in the high boost mode rotate the dial to raise or lower the boost target, careful though as it only needs very slight movement - if the screen flashes L rotate the dial anticlockwise until the boost target is correctly displayed, likewise if the screen flashes H rotate the dial clockwise to regain the displayed boost target.

 

Mitsubishi Lancer Register Forum - Technical

 

Hi

thanks for that guys


Craig

 

Just to let you know i've managed to lower high boost from 1.25bar to 1.2bar & after a couple of test runs everything is fine

Just need to save up for Ecutek now


Craig