HKS EVC IV boost controller help!!
 

Hi

i've got a HKS EVC IV boost controller fitted to my Evo5. I'm wanting to lower the high boost setting from 1.25bar to 1.2bar. Does anybody know how to do it as i haven't got a manual or clue how to do it :roll:

Don't just wanna start pressing buttons to find out how it works cos i'm likely to break something :wink:

Oh & i've found the pdf manual for it but i can't find anything that tells me how to alter it once it's all been set. Just tells me how to set it all from scratch with learning mode etc & i don't wanna reset it & start from scratch. Don't wanna bugger it up totally :)

BTW i do realize this is a Scooby forum & i have an Evo but i've asked on here cos generally a lot more people use this forum & technically it's not an Evo issue, it's a HKS product issue ;)

Thanks in advance


Craig 8)

Come on!!!

Somebody on here must have a EVC IV & know how to use it??


Craig :cool:

Whilst in the high boost mode rotate the dial to raise or lower the boost target, careful though as it only needs very slight movement - if the screen flashes L rotate the dial anticlockwise until the boost target is correctly displayed, likewise if the screen flashes H rotate the dial clockwise to regain the displayed boost target.

Hi

thanks for that guys ;)


Craig :cool:

Just to let you know i've managed to lower high boost from 1.25bar to 1.2bar & after a couple of test runs everything is fine ;)

Just need to save up for Ecutek now


Craig :cool: