scoobzie

hi guys i have bought a k&n 57 induction kit for my classic 2000 turbo my99/00 the only mod is a baileys dumpvalve i no this kit bolts straight on but will i need a remap for the car to run right or will it be fine with just putting it straight on and will there be any bhp increase cheers scoobzie

fireblade37

iTrader: (1)

Hi, i first brought my00 5 years ago not knowing anything about them. First mod k&n 57i kit, turbosmart bov, decat down pipe. After four weeks of motoring with the mods it went BANG. Scrap the bov scrap the k&n unless your going to get it remapped soon and use the o/e bov and a panel filter. Mine went bang because the induction kit had killed the maf sensor and that was that

WRXTek

I can only tell you of my experience with the sti.
I ran a k&n intake for a couple of months before i got a remap.
When I did go for the remap, I was told by tuner can was running a bit lean.

joe79er

i am thinking of doing that as well scoobzie, but if the case is it wont run or break then i will wait until i have the money for a remap aswel

WRXTek

the best thing is to get an intake, exhaust, fuel pump, and remap all at the same time.

4evermad

iTrader: (1)

put a good panel filter in. still get cold air from the inner wing standard air box should be good for 300+bhp scott

scoobzie

i would put a panel filter in but i have already purchased the indution kit will just ave to buy the othe parts and get the remap done will talk with andy f and see whn hecan book me in
cheers fo the help guys scoobzie