Bolting heads to a new block with ARP's
#1
Scooby Regular
Thread Starter
Join Date: Oct 2004
Location: Johannesburg - SOUTH AFRICA
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
Bolting heads to a new block with ARP's
Hi, just want to get a 2nd opinion on this. I would like info from start to finish of bolting heads to a new block with ARP's. From hand threading the studs into the block onwards please.
Thank you!
Thank you!
#2
Scooby Regular
Join Date: Mar 2007
Location: The right side of 30psi
Posts: 539
Likes: 0
Received 0 Likes
on
0 Posts
Well you should have a small allen key hole in the top of the stud to get it in nice and tight, you lightly lube the thread with moly grease.
Put the head on, put some more lube on both sides of the head washers, lightly lube thread and put the nuts on, in the correct sequence you tighten the head in three stages, 30lb/ft, 60lb/ft, then 90lb/ft.
Put the head on, put some more lube on both sides of the head washers, lightly lube thread and put the nuts on, in the correct sequence you tighten the head in three stages, 30lb/ft, 60lb/ft, then 90lb/ft.
Thread
Thread Starter
Forum
Replies
Last Post
bluebullet29
General Technical
9
05 October 2015 02:17 PM