Ok folks, managed to aquire an avcr only problem is the wiring harness for it has been bodged in the past and as such is now in 4 parts,

part one is the control unit which has the full harness on it with 11 wires, grey, yellow, blue, brown, white, purple, orange, red, black, green, and pink

part two is the pressure sensor, which has its original wiring harness, including pink, white and black, which then goes into the conector and out the other part of the contector is yellow, brow, blue. pink to yellow, black to brown, and white to blue

part 3 is the solinoid, which again has its original harness with black and red wires, into a conector and comes out red and pink, red to pink and black to red

Part 4 is a switch, with no wires on it,

question is how are these all suposed to be wired together,

hope someone can help

cheers

kinghorn

 

ANYONE GOT one thats not fitted yet that can have a look at the wiring for me,

please

 

ANYONE

 

A'PEXi U.S.A. - Products: Electronics

http://www.apexi-usa.com/pdf/technic...tation/200.pdf

Is this any use ?

Has the 11 wire multi connector been chopped off or do you just need the wiring diag in the link above ?

Andy

 

the 11 wire conector is there andy, its the loom between the 3 bits thats missing,

i tried calling you friday, will try on monday

 

STILL STRUGGLING WITH THIS, ANYONE ABLE TO HELP

 

STILL STRUGGLING WITH THIS, ANYONE ABLE TO HELP

 

the complete loom missing.. ie. you have the unit with a wire and 11way plug and then the plugs on the solenoid and map sensor?

Simon

 

YES, simon thats correct,

sorry for delay