550cc sti7 injectors for sti3
20 May 2007, 10:39 AM
#1
Scooby Regular
Thread Starter
Join Date: Aug 2004
Location: brussels, belgium
Posts: 674
Likes: 0
Received 0 Likes
on
0 Posts
550cc sti7 injectors for sti3
i been offered a set of 550cc sti7 injectors and i allready bought a walbro 255l fuel pump, can i fit both without needing a remap?
would cause this set up damages if not mapped?
cheer
would cause this set up damages if not mapped?
cheer
20 May 2007, 11:36 AM
#3
Former Sponsor
iTrader: (20)
Join Date: Oct 2006
Location: 8.95 @ 168mph. Zero to 1KM 194.1mph
Posts: 1,150
Likes: 0
Received 0 Likes
on
0 Posts
You can't fit the injectors at all. They are top feed, and your STi3 is side feed.
Pump on it's own shouldn't need a re-map.
Mark.
Pump on it's own shouldn't need a re-map.
Mark.
20 May 2007, 12:20 PM
#4
Scooby Regular
Thread Starter
Join Date: Aug 2004
Location: brussels, belgium
Posts: 674
Likes: 0
Received 0 Likes
on
0 Posts
and about mapping, as a v3 sti how is possible as i've been told that pre 1998 ECU are not mappable.
thanks again
20 May 2007, 01:42 PM
#5
Former Sponsor
iTrader: (20)
Join Date: Oct 2006
Location: 8.95 @ 168mph. Zero to 1KM 194.1mph
Posts: 1,150
Likes: 0
Received 0 Likes
on
0 Posts
There are injectors available for your car. If you give me a call tomorrow, I'll give you the options.
With regard to re-mapping, the 97-98 ecu's can't be directly mapped, and you will need either a solder in piggyback board, or easier, and alternative ecu, such as the Apexi Power FC.
Mark.
With regard to re-mapping, the 97-98 ecu's can't be directly mapped, and you will need either a solder in piggyback board, or easier, and alternative ecu, such as the Apexi Power FC.
Mark.
20 May 2007, 02:23 PM
#6
Scooby Regular
Thread Starter
Join Date: Aug 2004
Location: brussels, belgium
Posts: 674
Likes: 0
Received 0 Likes
on
0 Posts
There are injectors available for your car. If you give me a call tomorrow, I'll give you the options.
With regard to re-mapping, the 97-98 ecu's can't be directly mapped, and you will need either a solder in piggyback board, or easier, and alternative ecu, such as the Apexi Power FC.
Mark.
With regard to re-mapping, the 97-98 ecu's can't be directly mapped, and you will need either a solder in piggyback board, or easier, and alternative ecu, such as the Apexi Power FC.
Mark.
, this because i do that trough the Scoobynet forum!how much, where to find fit and map the apexi power fc??
Daniel
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM