just replaced my TD04 with TD05 and..
18 May 2007, 05:42 PM
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Aug 2006
Location: North West
Posts: 236
Likes: 0
Received 0 Likes
on
0 Posts
just replaced my TD04 with TD05 and..
...fitting everything back together ive found that the coolant pipes that come off the TD04 are too small to fit the TD05.. damn! 
anyone know where i can get the coolant pipes from, looking on ebay i can only find this
eBay.co.uk: SUBARU TD05H turbocharger water cooling oil drain kit (item 320091035321 end time 07-Jun-07 04:07:04 BST)
TA!
anyone know where i can get the coolant pipes from, looking on ebay i can only find this
eBay.co.uk: SUBARU TD05H turbocharger water cooling oil drain kit (item 320091035321 end time 07-Jun-07 04:07:04 BST)
TA!
18 May 2007, 09:45 PM
#3
Scooby Regular
Drill them out with a 9/16" or 14mm drill bit. As long as you've got the correct bolts for the water inlet and outlet you're OK, an overbore is all you need. I just did it with mine a couple of weeks ago. That kit on ebay will do it if you have got the time to wait. I was in a hurry so just drilled mine oversize.
19 May 2007, 10:26 AM
#5
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Aug 2006
Location: North West
Posts: 236
Likes: 0
Received 0 Likes
on
0 Posts
Silent running,
thats a very good idea, as the M12 banjo bolts used on the td04 are quite loose in the pipes anyway.
Still need some M14 banjo's though - seems as thought loads of places do M10 bolts..
thats a very good idea, as the M12 banjo bolts used on the td04 are quite loose in the pipes anyway.
Still need some M14 banjo's though - seems as thought loads of places do M10 bolts..
Thread
Thread Starter
Forum
Replies
Last Post
Phil3822
General Technical
0
30 September 2015 06:29 PM
hedgecutter
General Technical
3
25 September 2015 02:35 PM
