Mounting induction kit under bonnet scoop w/ FMIC
#1
Scooby Regular
Thread Starter
Join Date: Nov 2006
Location: Fermanagh/Tyrone
Posts: 579
Likes: 0
Received 0 Likes
on
0 Posts
Mounting induction kit under bonnet scoop w/ FMIC
Anyone tried this? Placing the induction behind the throttle body so that cold air is forced down onto it from the bonnet scoop.
Might see if I can conjure up the pipework and give it a go...
Might see if I can conjure up the pipework and give it a go...
#2
Scooby Regular
iTrader: (6)
Join Date: Apr 2004
Location: HELL
Posts: 1,839
Likes: 0
Received 0 Likes
on
0 Posts
I was also thinking about the same thing but how would you get the pipe to twist round past the Turbo? unless you used a thiner pipe , which would also have a affect on the amount of air going in
#3
Scooby Regular
That's gonna be some plumbing to do that. And you'd be moving it right above the gearbox and block - not that much better while you're moving, much hotter at standstill.
Thread
Thread Starter
Forum
Replies
Last Post
shorty87
Full Cars Breaking For Spares
19
22 December 2015 11:59 AM
supshon
General Technical
2
03 October 2015 08:06 PM