Ian

iTrader: (10)

anyone know anything about this?

i think it is for a boost map, it is wired in with the f-con.

it is on a turbo honda engine.

any wiring diagrams would be very good

thanks

Sc0oby

nope this wouldnt work for your subaru. That mini f-con is wire up to the map sensor/injectors/ground n 12 volts. This is main use to clamp down the voltage of the map sensor of honda to prevent the check engine coming on when the map sensor read positive boost

Ian

iTrader: (10)

on the mini f-con, there is a white wire, but we dont know where it goes, it wont rev if it is connected to earth. but car runs if it is not on a earth.

any idea where it should go?

p.s got a apexi fc in me scoob :-)

Sc0oby

white wires if i am not mistaken is connected to the map sensor of the honda.

Ian

iTrader: (10)

do you know of any wiring diagrams for thsi at all?

Sc0oby

yellow and white is connected to the map sensor for honda. i have the diagram somewhere in the workshop i should go n check it out if you need it. I am sure this wouldnt work for the scooby as this is a use for the honda 1 bar map sensor

Ian

iTrader: (10)

it isnt for me, my friend as put a intrega type r engine with hks turbo etc into his honda del sole. but we have got this one white wire from the mini f-con that we dont know where it goes.

if you could email me the diagrams if you can find them, it would be vvvvv helpfull
ianjones32@yahoo.co.uk

thanks
ian

Sc0oby

blue = injector #1
purple = injectors #4
orange = injector #2
pink = injector #3
brown = ignition pulse
gray = power ground
black = logic ground
red = ecu main supply
yellow = map sensor ecu side
white = map sensor harness side

Ian

iTrader: (10)

hi thank you loads for the help nobody new anything on the honda forums all sorted now one very happy honda owner gotta love the scoobs though