MAF
09 April 2007, 02:13 PM
#1
Scooby Regular
Thread Starter
Join Date: Nov 2006
Location: cardiff
Posts: 65
Likes: 0
Received 0 Likes
on
0 Posts
MAF
Hi all,
Just had my MAF out and there are 2 connectors (they look like 2 small copper things) sticking out just before the sensor head inside the inlet.Should these be connected to anything because there don't seem to be anything inside the inlet pipe to connect to?They are about 1cm apart.
The reason I checked is because after a very recent rebuild,the engine is still going **** up.Checked for any fault code and I got 23 and 32.the former is Maf and i think the latter is lamda.Please tell me if I'm wrong and do you think an ECU reset is in order?
Ta!
Just had my MAF out and there are 2 connectors (they look like 2 small copper things) sticking out just before the sensor head inside the inlet.Should these be connected to anything because there don't seem to be anything inside the inlet pipe to connect to?They are about 1cm apart.
The reason I checked is because after a very recent rebuild,the engine is still going **** up.Checked for any fault code and I got 23 and 32.the former is Maf and i think the latter is lamda.Please tell me if I'm wrong and do you think an ECU reset is in order?
Ta!
Last edited by spit; 09 April 2007 at 02:35 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM