ball park figure to ceramic coat headers
#2
Former Sponsor
iTrader: (20)
Join Date: Oct 2006
Location: 8.95 @ 168mph. Zero to 1KM 194.1mph
Posts: 1,150
Likes: 0
Received 0 Likes
on
0 Posts
Sounds like Zircotech ? If so, they are VERY good, and not to be compared with some of the alternatives.
However, I would suggest you measure just how many feet there are in a set of headers/up pipe, so you don't get too much of a shock.
Mark.
However, I would suggest you measure just how many feet there are in a set of headers/up pipe, so you don't get too much of a shock.
Mark.
#4
Scooby Regular
Thread Starter
Join Date: Jan 2006
Location: Wellingborough
Posts: 1,107
Likes: 0
Received 0 Likes
on
0 Posts
Yes thats the place spoke to them on the phone today. Def going to give it a go i've had enough of re-wrapping every year. I'll let you know how i get on when i drop them down next week.
#7
Scooby Regular
Thread Starter
Join Date: Jan 2006
Location: Wellingborough
Posts: 1,107
Likes: 0
Received 0 Likes
on
0 Posts
Had them done by a company called Zircotec they are based on the atomic energy park at harwell just off the A34 near Abingdon Oxfordshire. They are in fact as allready mentioned earlier on in this thread the company responsible for coating the Prodrive parts for the Subaru WRC team.They are also doing parts for the litchfield type 25's. The quality seems to be supurb and the finish is very hard and durable. Cost was 350 quid including VAT seems a lot but mine are perfect equal length so may be little longer then most and at least i won't spend out on wrap anymore !!
Trending Topics
#12
Former Sponsor
Join Date: Jul 2005
Location: Wellingborough, Northamptonshire
Posts: 2,859
Likes: 0
Received 0 Likes
on
0 Posts
The Zircotec stuff is much thicker than pretty much every other ceramic coating I've seen. The Jet Hot coating is like the "satin black" and "ceramichrome" (sp?) coatings AFAIK, and pretty thin. Although the thinner coatings can successfully be applied to the inside of some pipework, whereas the Zircotec doesn't make this possible.
Paul
Paul
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
Pro-Line Motorsport
Car Parts For Sale
2
29 September 2015 07:36 PM