engine identification please?
Former Sponsor
iTrader: (4)
Joined: Jan 2001
Posts: 16,548
Likes: 2
From: ECU Mapping - www.JollyGreenMonster.co.uk
no but you can tell if it is closed deck by looking for the criss cross markings on the block .. they are obvious on the heads.. need to then check if the block has it, on front or rear.
Simon
Simon
It's listed here:
http://www.freenetpages.co.uk/hp/ken...sti/index.html
As JGM said above - look for cross hatching on the block and the casting where the Modine/oil filter bolts to,to tell if its a CDB.
You cant tell much else without removing one of the heads to see what valvetrain,cams and valve codes its got(unless you have access to a Endoscope to look down the bores)
http://www.freenetpages.co.uk/hp/ken...sti/index.html
As JGM said above - look for cross hatching on the block and the casting where the Modine/oil filter bolts to,to tell if its a CDB.
You cant tell much else without removing one of the heads to see what valvetrain,cams and valve codes its got(unless you have access to a Endoscope to look down the bores)
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
Dec 28, 2015 11:07 PM




