thewhitewarrior

how do i separate the clutch plate so i can pull the box off on a 95 sti, cheers phil.

thewhitewarrior

i have been told about a pin in there somewhere but where is it and how do i access it.

WUZ

iTrader: (14)

Remove Starter motor.

At the side of the gearbox near the starter their is an M18X1.5 plug with an allen key head on it (8mm). Remove this plug.

Inside is the clutch fork Pivot shaft and in the end of this shaft is a threaded hole. Insert a bolt into this and wiggle out the shaft (might be stiff but be patient).

Once this shaft is removed, you can lift the clutch fork up and clear of the release bearing on the clutch.

NOW YOU CAN START TO GET ON WITH REMOVING THE GEARBOX!

Have fun!

Russell

thewhitewarrior

nice one russell, your advise was spot on, i found it straight away and pulled it out, thanks very much.