Check Engine Light
#1
Check Engine Light
Hi all, my engine warning emissions light came on this morning on the way to work (2002 ppp wrx). I had just overtaken someone on full boost in 3rd. The car and engine is running fine the temperature is fine. Has anyone expereinced this before and is this common on the bugeye with no other signs of anything wrong?
Any ideas or past experiences would be great, i'm thinking of dropping it down to the local dealer to take a look at error codes.
Thanks. Nick
Any ideas or past experiences would be great, i'm thinking of dropping it down to the local dealer to take a look at error codes.
Thanks. Nick
#2
Nick
I have problems with full boost overtaking with my MY02 bugeye...... The SECS gives a camshaft position sensor error . It should go away after 4 or 5 starts.
Its the Bugeye random CEL generator again LOL.
Cheers
Shaun
I have problems with full boost overtaking with my MY02 bugeye...... The SECS gives a camshaft position sensor error . It should go away after 4 or 5 starts.
Its the Bugeye random CEL generator again LOL.
Cheers
Shaun
#3
Scooby Newbie
Join Date: Feb 2007
Location: Milton Keynes
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Hi all, my engine warning emissions light came on this morning on the way to work (2002 ppp wrx). I had just overtaken someone on full boost in 3rd. The car and engine is running fine the temperature is fine. Has anyone expereinced this before and is this common on the bugeye with no other signs of anything wrong?
Any ideas or past experiences would be great, i'm thinking of dropping it down to the local dealer to take a look at error codes.
Thanks. Nick
Any ideas or past experiences would be great, i'm thinking of dropping it down to the local dealer to take a look at error codes.
Thanks. Nick
Not had this on my current WRX STI but had this on my previous Turbo 2000, dealer replaced an air sensor/relay, sorted !
Regards,
Andy.
Last edited by Fishboy5; 20 February 2007 at 02:19 PM.
#4
Had it checked out since it was annoying me, exactly the same as yours - bloody Camshaft sensor, all reset and havent seen the light at all.
Thread
Thread Starter
Forum
Replies
Last Post
charlesr
General Technical
9
28 September 2015 09:16 AM
TylerD529
Lighting and Other Electrical
5
20 September 2015 12:10 PM