Stripped Cyl 3 threads off - **** :(
13 February 2007, 11:17 PM
#1
Scooby Regular
Thread Starter
iTrader: (4)
Join Date: Sep 2006
Location: Durham
Posts: 1,238
Likes: 0
Received 0 Likes
on
0 Posts
Stripped Cyl 3 threads off - **** :(
no longer required as it was just thread lock
Last edited by Andygreer; 29 May 2007 at 09:34 PM. Reason: No longer needed
13 February 2007, 11:42 PM
#3
Former Sponsor
iTrader: (4)
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes
on
2 Posts
if the bolt went back in with no issue then I suggest the thread is wrong on the adaptor..
buy from a breaker the adaptor that fits the OE oil pressure switch into the block below the alternator.. this will have the correct thread.
Simon
buy from a breaker the adaptor that fits the OE oil pressure switch into the block below the alternator.. this will have the correct thread.
Simon
14 February 2007, 08:23 AM
#4
Scooby Regular
Thread Starter
iTrader: (4)
Join Date: Sep 2006
Location: Durham
Posts: 1,238
Likes: 0
Received 0 Likes
on
0 Posts
threads should be the same its from the kit from LTA (of wht ever there called) i purchased it from ASP in Birtley whom are Subaru Spec..
Ill do as you say the Green thanks very Much
Ill do as you say the Green thanks very Much
Thread
Thread Starter
Forum
Replies
Last Post