problem starting after been run for 10 mins
09 February 2007, 07:35 PM
#1
Scooby Newbie
Thread Starter
Join Date: Jul 2006
Location: crewe
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
problem starting after been run for 10 mins
start first time when been standing for a while. if you go back to the car with in five or ten mins the flipping thing will not start any ideas. it will start if you keep the thing turn over after about 10 mins
change plugs leads
change plugs leads
09 February 2007, 09:32 PM
#2
Former Sponsor
iTrader: (4)
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes
on
2 Posts
classic sign of a failing crank sensor.. cleaning it usually helps for a little while.
it is located on the front of the engine between the pulley belts.. the cam sensor looks identical and is below the oil filler with a 10mm bolt head holding it on.. look at that and then locate the crank sensor..
Simon
it is located on the front of the engine between the pulley belts.. the cam sensor looks identical and is below the oil filler with a 10mm bolt head holding it on.. look at that and then locate the crank sensor..
Simon
Thread
Thread Starter
Forum
Replies
Last Post
aaron_ions
General Technical
17
03 November 2021 11:07 AM
ATWRX
Full Cars Breaking For Spares
88
01 February 2016 07:28 PM
Uncle Creepy
Other Marques
43
27 December 2015 04:02 PM
Bazil_SW
Engine Management and ECU Remapping
24
21 September 2015 11:55 PM
aaron_ions
General Technical
1
17 September 2015 10:42 AM