Need some advice im fitting a sti intercooler for the moment but when i went to fit the unit/valve in the bottom right corner is getting in the way what is it and how do i get round it




This is what im fitting untill the next group buy for the front mount



Or do i just sell it and wait

CHEERS KIP

 

Cut off the alloy pipe & have a plate tig welded over the hole.
Thats what I had done to mine.

 

As above, then add a tube for the dumpvalve on the piping that goes to the turbo.

 

As above or remove the red hose & buy the samco version 1/2 turbo hose kit. That way you will be able to retain your standard dv & its position.

Note the samco hose is longer than required, so a bit of trimming down to suit.

 

Might just bite the bullit and sell them both and get the front mount. canthe front mount be fitted slightly back so i can keep the lowergrill inplace I know i have to cut the bumper but if their is just enough room i could trim the grill down and weld it back in
KIPS

 

What front mount you looking at?

I'm after one but not sure what to get

 

Their was a group buy just before xmas think they got them for the £195 mark so was gonna see if they have any back in stock yet if you go to group buys you will see them their
KIPS

 

Hi m8 just wondering if you want to sell the arc intercooler if so how much cheers

 

https://www.scoobynet.com/group-buys...=1#post6581333
KIPS

 

I would'nt waste my money on a cheap frontmount, the flow rates are s**t!! Unless your looking at doing alot of trackdays or running huge amounts of power they ar'nt worth it. You'r much better off fitting a larger sti topmount!! I'v just finished fitting an sti8 intercooler to my m/y94 sti1!!