Knock display on commander AND a knocklink?
#1
Knock display on commander AND a knocklink?
My classic WRX has a knocklink that I fitted before my Power Fc and commander appeared. Since AndyF mapped the car I have had absolutely ZERO knocklink activity and the commander only shows a max of 14 for the knock. So I tested the old knocklink today by tapping the head of the bolt that secures the sensor with a screwdriver. All the lights lit up!!
So my question is this. Is there any point having a knocklink and a Commander for displaying knock if my engine is this quiet?
Is the commander to be trusted?
Edited to say: PSLewis and his c**klink jokes are not welcome.
So my question is this. Is there any point having a knocklink and a Commander for displaying knock if my engine is this quiet?
Is the commander to be trusted?
Edited to say: PSLewis and his c**klink jokes are not welcome.
Last edited by Welloilbeefhooked; 11 January 2007 at 08:35 PM.
#2
The commander is good enough to measure the Knock activity.
Your better off just selling the Knocklink.
To avoid you from keeping your eyes on the commander, the CEL light will flash on if there is any excessive det. Andy would have set the level of det that will activate the CEL.
Your better off just selling the Knocklink.
To avoid you from keeping your eyes on the commander, the CEL light will flash on if there is any excessive det. Andy would have set the level of det that will activate the CEL.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM