Inlet manifold spacers..
22 December 2006, 01:07 PM
#1
Scooby Regular
Thread Starter
iTrader: (23)
Join Date: May 2006
Location: Rota Subzeros FOR sale!
Posts: 3,701
Likes: 0
Received 0 Likes
on
0 Posts
Inlet manifold spacers..
I saw pic on the NASIOC site and someoone had fitted the spacers between the TGV and the inlet manifold rather than the block and the TGV on their bugeye, what would be the difference doing this or doesni not make any difference where they go on a newage?
Thanks
S!
Thanks
S!
22 December 2006, 03:23 PM
#5
The job of getting the whole of the inlet manifold + TGV bodies compared with lifting the top half of inlet to leave the TGVs in place is very minor.
I've not seen TGV spacers but they would be smaller than traditional inlet spacers so in theory they should be cheaper. New longer studs to join TGV bodies to inlet will be needed though.
nick
I've not seen TGV spacers but they would be smaller than traditional inlet spacers so in theory they should be cheaper. New longer studs to join TGV bodies to inlet will be needed though.
nick
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM