Knock signal reading apexi AFC II.
#1
Knock signal reading apexi AFC II.
I need help for the S-AFC II.
I have had installed the SAFC II for one year. I use it to calibrate the AF ratio but i have read on it one control that aparently is the knock signal. It is strange but it appears almost always in 0. Sometimes at idle it turns to 7, 8, 9 One time until 15, 16. But when i push the gas the monitor shows 0 again.
Somebody that can explain how to read this please!
I read also that conecting the Blue wire you can read the voltage of the O2 Sensor. Is that thrue? if so, how can you show this on the screen?
thanks in advance from Peru.
LG
I have had installed the SAFC II for one year. I use it to calibrate the AF ratio but i have read on it one control that aparently is the knock signal. It is strange but it appears almost always in 0. Sometimes at idle it turns to 7, 8, 9 One time until 15, 16. But when i push the gas the monitor shows 0 again.
Somebody that can explain how to read this please!
I read also that conecting the Blue wire you can read the voltage of the O2 Sensor. Is that thrue? if so, how can you show this on the screen?
thanks in advance from Peru.
LG
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM