I just spent the afternoon putting on a samco turbo and ancillary hose kit
got all hoses on bar 1
this pipe you have to remove the one way valve from the old pipe and put it into the new pipe
anyone done this before?
is there an easy way of getting it out of ther hose other than cutting the old hose?
then when its out is it easy to push into the new hose?
is there a knack to it?
or can you pick up these non return valves at your local halfrauds????
any ideas??? cheers
pic below of hose in question

 

just cut mine open

and pushed it back in with a hose clamp driver, i wouldnt push to hard on the centre valve part

just give it a quick test by sucking and blowing on the pipe before you finish as if it fails you will be in the ****