Does anybody have an aircon installation guide for a MY99/00 Classic turbo ?
ANy help is wanted, I have the kit but don't knwo where to start
(Need to unbolt it from a car, then transplant it to mine..)

 

Got the guide on my work lappie, PM your email addy & I'll mail it tomorrow eve.

D

 

hi
would you mind emailing me your guide aswell

 

No probs PM me your mail address.

D

 

pm sent

 

Anyone want to buy the aircon off my my00? Be available in 5-6 weeks.

Richard

 

i could be interested what asking mate

 

Have an aircon, need a guide...

 

Guide now sent to you both, if you do a search on here there's a few experiences in fitting.

D

 

cheers mate

 

Thanks, just need to remember that I have a Euro type, so my engine compartiment is slightly "mirror image"...
Thanks for the guide, it wil be real helpful...

 

Don't know - what is it worth?

Richard

 

I bought mine for 350 € exclude the condensor (in front of the radiator), wich will be a new one.
Not an original part, they charge 500€ for it, a local radioator/cooler factory has it in stock for 120 €
So for 470€ I have a fully working aircon + cost of filling up.

 

Best offer on 500 Euro then, thanks!

Richard

 

Richard, thanks for the info, from the help that the circuit diagram gave me I find I'm just short of an "Evaporation thermostatic switch unit" This seems to be a small module with a 3 pin connector that goes in the evaporation unit near the heater fan housing. From what I can see its an active device with a thermistor and an amplifier. It takes a positive 12V supply and the switched earth from the A/C switch. The output from it sends a signal to the ecu to switch on the A/C relay and the fans. I've temporarily bypassed this with a relay and all is working fine, just need to get the system pressurised, hopefully very soon.

So, can anyone help with the evap thrmo unit I need? What does it look like? can it be purcahsed new, if so how much?

thanks,

Martin

 

Now I find that there is a leak! The pipe that goes from the pump to the condenser, it's the wrong fitting at the pump end (Sti4 Pump), I now need a replacement pipe that has a larger fitting to the pump, can anyone help?

Martin