sponners

iTrader: (4)

Hi all!

I'm looking at fitting a chipped ecu to my '93 wrx (which runs 1.2bar), but have been told by a few people that the standard solenoid valve won't be able to keep up! - causing creep

Wondering - is the apexi boost solenoid a direct/replacement fit??? as I'm guessing this would cure boost creep problem!

I heard somewhere that it has a map sensor built in, is this true??

cheers
Mark.

Jolly Green Monster

iTrader: (4)

standard ecu cannot be mapped to 1.2bar safely as the original MAP sensor tops out at 1.23bar.. creap would be because the ecu would be seeing 1.23bar and adjusting the duty down slightly not realising the boost in the mean time is creaping to 1.4bar etc..

There is nothing wrong with the standard 3port.

The Apexi 3 port is a direct replacement but would make no difference in this case.

No it doesn't have a built in map sensor.

Simon

sponners

iTrader: (4)

cheers, didn't realise that!

so where, and how much can I get a uprated map sensor from?

thanks again
Mark.

sponners

iTrader: (4)

I can see thers someone off here selling a '99 map sensor (converted to plug straight in), will this be upto the job do you think?

Jolly Green Monster

iTrader: (4)

the ecu needs mapping to the new map sensor.. if it is not set up to the new one it will not run correctly..

sponners

iTrader: (4)

are all chipped (piggyback) ecu's mappable?

can someone come out to me or does it need to be done on a rolling road?

what sort of cost am I looking at to get it mapped?

cheers bud

Mark.

sponners

iTrader: (4)